Trigger Sprayer is an essential device to clean gunk from your paintwork when done properly. If you want to clean up gunk on your guns or other piece of equipment using Trigger Sprayer, you need to know what tools you will need to use to make the job easier.
To get started, make sure your intended sprayer and cylinder are compatible with your intended container; for instance, if you are using a trigger sprayer intended for your pistol, you will need to use a pistol cap. The first number in the neck end of a neck piece refers to the threading style and the second number to the diameter in centimeters. The Threading refers to how tightly the material is closed around the piston. On the other hand, the Diameter refers to how far the material will go down in the bore of the piston. The material is always measured in centimeters. You will want to make sure you use the correct value for your intended diameter and accordingly attach the caps.
Next, attach the caps and then insert your finger into the trigger sprayer to insert the hose into the piston. Using the needle nose pliers, remove any o-rings and air valves that may be present on the piston. Next, turn the valve counterclockwise to free the trapped air. Once the air is released, remove the needle nose pliers, and set aside the piston for now. You will now remove the gasket from the inside of the piston.
Using a damp rag or towel, gently wipe away any of the excess gasket and lubricant that may remain. If there is any left over, apply some cleaning solutions to help take care of the problem. Be sure to keep the area clean and dry after cleaning, as excess moisture and dirt can prevent proper functioning of the trigger sprayer. After applying the cleaning solutions to your trigger sprayer, you will now need to attach the hose and nipple to your air cleaning system.
With your upholstery cleaners, you should be able to clean the feeder and the valve covers. Once you are done cleaning the feeder and valve covers, attach them to your machine by feeding the hose and nipple through the feeder and into the valve covers. Once you have placed the hose and nipple into the feeder, you should check the level of the cleaners. If the cleaners are too full, you may need to add more cleaning solutions. If they are not too full, the trigger sprayer will not work properly.
The last step is to insert the hose into the trigger sprayer and push the handle to send a jet of cleaning products through the hose at high pressure. Once you are done, reconnect the hoses and pump to their respective connections on the machine. Check the power switch to make sure it is working correctly. If you did everything correctly, your air conditioner should be running cool air for many hours straight. However, if the machine suddenly becomes very hot, it could be an indication that the power has been cut by an outlet.